Steering

Power Steering Oil Pump

~1min read
Inspection

Connect the Tool between power steering oil pump discharge connector and high-pressure hose. Bleed air from the hydraulic circuit while opening valve fully. Refer to Air Bleeding Hydraulic System.

Tool numbers

: KV48103500 (J-26357)

: KV48102500 (J-33914)

Start engine. Run engine until power steering fluid temperature reaches 50° - 80 °C.

Fully close the Tool valve with engine at idle and measure the relief oil pressure.

Relief oil pressure : Refer to Power Steering Oil Pump.

Open the valve slowly after measuring. Replace the power steering oil pump if the relief oil pressure is outside the standard.

After inspection, disconnect the Tool from hydraulic circuit, then add fluid and bleed air. Refer to Air Bleeding Hydraulic System.