Brakes

Rear Disc Brake

~3min read
Exploded View
1. Torque member 2. Bushing 3. Piston boot
4. Slide pin boot 5. Slide pin 6. Piston
7. Piston seal 8. Brake caliper body 9. Bleeder cap
10. Brake hose 11. Copper sealing washers 12. Inner shim cover
13. Inner shim 14. Inner pad 15. Pad retainer
16. Outer pad 17. Outer shim 18. Outer shim cover
A. Niglube Rx-2 B. Rubber grease C. Molykote® AS-880N
: Apply brake fluid.
Disassembly and Assembly

DISASSEMBLY

Remove the brake caliper from the vehicle. Refer to Removal and Installation.

Remove slide pin boots from torque member.

Remove slide pin bushing from slide pin.

Place a wooden block in the cylinder body and blow air from union bolt hole to remove piston and piston boot.

Remove piston seal from brake caliper body using suitable tool.

Remove bleeder valve and cap.

INSPECTION AFTER DISASSEMBLY

Brake Caliper Body

Check the inner wall of the brake caliper body for rust, wear, cracks or damage. Replace the brake caliper body if any abnormal condition is detected.

Torque Member

Check the torque member for rust, wear, cracks or damage. Replace the torque member if any abnormal condition is detected.

Piston

Check the surface of the piston for rust, wear, cracks or damage. Replace the piston if any abnormal condition is detected.

Slide Pin and Slide Pin Boot

Check the slide pins and slide pin boots for rust, wear, cracks or damage. Replace the parts if any abnormal condition is detected.

ASSEMBLY

Install bleeder valve and cap.

Apply rubber grease to piston seal (1), and install it to the brake caliper body.

Apply rubber grease to piston boot (1). Cover the piston (2) end with the piston boot, and then install cylinder side lip on the piston boot securely into the groove on brake caliper body.

Apply brake fluid to piston (1). Push piston into brake caliper body by hand and push piston boot (2) piston side lip into the piston groove.

Apply Niglube Rx-2 grease to bushing; install bushing to slide pin.

Apply Niglube Rx-2 grease to slide pin boots and slide pins.

Install slide pin boots and slide pins to torque member.

Install the brake caliper to the Nissan Murano vehicle. Refer to Removal and Installation.

INSPECTION AFTER INSTALLATION

Check the drag of rear disc brake. If any drag is found, follow the procedure described below.

Remove brake pads.

Using a suitable tool, press the pistons into the brake caliper body.

Install brake pads.

Depress the brake pedal several times.

Check the drag of rear disc brake again. If any drag is found, disassemble the brake caliper body.

Burnish contact surfaces after refinishing or replacing disc brake rotors or if a soft pedal occurs at very low mileage. Refer to Brake Pedal.