Steering

Steering Gear and Linkage

~2min read
Exploded View
1. Outer socket 2. Inner socket lock nut 3. Small boot clamp
4. Boot 5. Large boot clamp 6. Inner socket
7. Spacer 8. Rack bar (not serviceable) 9. Bracket
10. Steering gear
Disassembly and Assembly

DISASSEMBLY

Remove inner socket lock nut (A) and outer socket (1).

Remove boot clamps and boot.

Remove inner socket.

Remove spacer.

Remove bracket bolt and bracket.

ASSEMBLY

Install bracket and bracket bolt to gear housing.

Install spacer on the end of the rack bar.

Apply medium strength thread locker to threads of inner socket. Tighten inner socket to the specified torque. Refer to Exploded View.

Install large end of boot (1) to gear housing.

Apply silicone grease between the inner socket and small end of boot (2). Install small end of boot to inner socket boot mounting groove.

Install small boot clamp.

Install large boot clamp using Tool.

Tool number : KV40107300 (J-51751)

Adjust inner socket to standard length (L), and then tighten inner socket lock nut to the specified torque. Refer to Exploded View. Check length of inner socket (L) again after tightening inner socket lock nut. Make sure that the length is the standard.

Inner socket length (L) : Refer to Steering Gear.