Body Interior

Steering Member Assembly

~2min read
Exploded View
1. Heating and cooling unit assembly 2. Steering member 3. Steering member brace (LH)
4. Steering member brace (RH) A. Steering member caps Pawl
Front
Removal and Installation

REMOVAL

Remove front wiper drive assembly. Refer to Removal and Installation.

Remove steering member bolt in engine room. Refer to Exploded View.

Remove the instrument panel. Refer to Removal and Installation.

Remove the center console. Refer to Removal and Installation.

Remove the TCU mounting screws.

Disconnect the harness connector, and then remove the TCU.

Remove center floor duct clip and place center floor duct aside. Refer to Exploded View.

Disconnect harness connector (A) from the air bag diagnosis sensor unit (1).

Feed steering member harness through center console bracket.

Disconnect harness connector from the shift selector assembly and release harness retainers.

Remove screws (A) and the ADAS control unit (1) and the around view monitor control unit (2) as an assembly.

Remove the left knee air bag module. Refer to Removal and Installation.

Remove right knee air bag module. Refer to Removal and Installation.

Remove screws (A) from fuse box (1).

Disconnect front harness connectors (B) and front relays (C).

Disconnect main harness connectors from junction box (LH/RH). Refer to Harness Connector (lever locking type).

Disconnect the front door harness connector (LH/RH).

Remove the nut and bolt and separate the steering intermediate shaft from the steering column. Refer to Exploded View.

Remove nuts from steering member braces and remove steering member braces. Refer to Exploded View.

Disconnect all necessary harness connectors and release harness retainers.

Remove heating and cooling unit assembly bolts. Refer to Exploded View.

Remove steering member caps. Refer to Exploded View.

Remove steering member bolts. Refer to Exploded View.

Using a suitable tool, adjust spacers (A) and remove the steering member from Nissan Murano vehicle.

INSTALLATION

Installation is in the reverse order of removal.