Tire Pressure Sensor

| 1. | Tire pressure sensor | 2. | Valve cap | 3. | Valve core |
| 4. | Valve | A. | Screw | : Parts that are replaced as a set when the tire is replaced. |
REMOVAL
Remove the wheel and tire using power tool. Refer to Removal and Installation.
Remove the valve cap and the valve core to deflate the tire. Refer to Exploded View.
Lubricate the tire outside bead well with a suitable non-silicone lubricant and separate the tire outside bead from the wheel.
Lubricate the tire inside bead well with a suitable non-silicone lubricant and separate the tire inside bead from the wheel.
Carefully lift and set the wheel and tire onto the tire changer turntable so that the tire pressure sensor (1) is at the bottom. Position the wheel and tire so that the tire pressure sensor is 270 degrees from the mounting/dismounting head (2).

Remove the tire from the wheel.
Remove the screw (A) and the tire pressure sensor (1) from the valve (2).

Cut the inner end (A) of the valve using a suitable tool (B).

Remove the valve (2) from the wheel (1) using Tool (A).

| Tool (A) number | : J-51980 |
INSTALLATION
Clean the valve hole in the wheel.
When reusing the tire pressure sensor, install the tire pressure sensor to the valve using the following procedure:Install the tire pressure sensor (1) to the roll pin (A) of the valve (2).


Apply a suitable non-silicone lubricant to the surface of the valve (A) that touches the wheel and to the valve hole in the wheel.

Position the tire pressure sensor assembly (1) on the wheel (2).

Install the tire pressure sensor assembly (2) to the wheel (1) using Tool (A).

| Tool (A) number | : J-51980 |
Check the tire pressure sensor assembly (1) position. The tire pressure sensor assembly must be installed to the wheel (2) as shown.

Apply a suitable non-silicone lubricant to the tire inside bead.
Install the tire inside bead (1) onto the wheel (2) in the position shown.

Place the wheel on the turntable of the tire machine. Make sure that the tire pressure sensor (1) is 270 degrees from the mounting/dismounting head (2).

Apply a suitable non-silicone lubricant to the tire outside bead.
Install the tire outside bead onto the wheel as normal.
Install the valve core.
Inflate the tire. Refer to Tire Air Pressure.
Install the valve cap.
Balance the wheel and tire. Refer to Adjustment.
Install the wheel and tire in the appropriate position on the Nissan Murano vehicle. Refer to Removal and Installation.