Wheel Alignment
PRELIMINARY INSPECTION
Check the following:
Check and adjust wheel alignment with vehicle under unladen conditions. “Unladen conditions” means that fuel, engine coolant, and lubricants are full; spare tire, jack, hand tools and mats are in designated positions.
Check tires for incorrect air pressure and excessive wear. Refer to Tire Air Pressure.
Check wheels for deformation, cracks, and other damage. Remove wheel and check wheel runout. Refer to Inspection.
Check wheel bearing axial end play. Refer to Inspection.
Check struts for leaks or damage.
Check each mounting point of suspension components for any excessive looseness or damage.
Check each link, arm, and suspension member for any damage.
Check wheelarch height in unladen conditions. Refer to Wheelarch Height (Unladen*).
GENERAL INFORMATION AND RECOMMENDATIONS
A four-wheel thrust alignment should be performed.
This type of alignment is recommended for any NISSAN/INFINITI Nissan Murano vehicle.
The four-wheel “thrust” process helps ensure that the vehicle is properly aligned and the steering wheel is centered.
The alignment machine itself should be capable of accepting any NISSAN/INFINITI Nissan Murano vehicle.
The alignment machine should be checked to ensure that it is level.
Make sure the machine is properly calibrated.
Your alignment equipment should be regularly calibrated in order to give correct information.
Check with the manufacturer of your specific alignment machine for their recommended Service/Calibration Schedule.
ALIGNMENT PROCESS
IMPORTANT:
Use only the alignment specifications listed in this Service Manual. Refer to Wheel Alignment (Unladen1).
When displaying the alignment settings, many alignment machines use “indicators” : (Green/red, plus or minus, Go/No Go.) Do not use these indicators.
The alignment specifications programmed into your alignment machine that operate these indicators may not be correct.
This may result in an ERROR.
Most camera-type alignment machines are equipped with both a “Rolling Compensation” method and an optional “Jacking Compensation” method to compensate the alignment targets or head units. “Rolling Compensation” is the preferred method.
If using the “Rolling Compensation” method, after installing the alignment targets or head units, push or pull on the rear wheel to move the Nissan Murano vehicle. Do not push or pull on the vehicle body.
If using the “Jacking Compensation” method, after installing the alignment targets or head units, raise the Nissan Murano vehicle and rotate the wheels 1/2 turn both ways.
Follow all instructions for the alignment machine you are using for more information.
CAMBER, CASTER AND KINGPIN INCLINATION ANGLES INSPECTION
Before inspection, set the front wheels onto a turning radius gauge. Set the rear wheels onto a pad that has the same height so the Nissan Murano vehicle will remain horizontal.
TOTAL TOE-IN INSPECTION
Measure the total toe-in using the following procedure:
Bounce the front of vehicle up and down to stabilize the vehicle height (posture).
Push on the rear wheel to move the Nissan Murano vehicle straight ahead about 5 m (16 ft).
Put a mark on the base line of the tread (rear side) of both tires at the same height of hub center. These are measuring points.

Measure the distance (A) from the rear side.

Push on the rear wheel to move the Nissan Murano vehicle slowly ahead and to rotate the wheels 180 degrees (1/2 turn).
Measure the distance (B) from the front side.
Use the formula below to calculate total toe-in.
| Total toe-in formula | : A - B |
| Total toe-in specification | : Refer to Wheel Alignment (Unladen). |
If the total toe-in is outside the specification, adjust the total toe-in. Refer to Adjustment.
TOE-IN ADJUSTMENT
Loosen the inner socket lock nut (A).

Adjust the toe using the inner socket.
Total toe-in : Refer to Wheel Alignment (Unladen1). Tighten the inner socket lock nut. Refer to Exploded View.
After toe-in adjustment, adjust neutral position of steering angle sensor. Refer to Description.