Suspension

Wheel and Tire

8steps
~48min
5/5difficulty
Done 0 of 8
Balancing Wheels

BALANCING WHEELS (ADHESIVE WEIGHT TYPE)

Preparation Before Adjustment

Remove inner and outer balance weights from wheel. Using releasing agent, remove double-faced adhesive tape from wheel and tire.

Wheel Balance Adjustment

  • If a balancer machine has an adhesive weight mode setting, select the adhesive weight mode setting and skip Step 2 below. If a balancer machine only has the clip-on (rim flange) weight mode setting, follow Step 2 to calculate correct size adhesive weight.

  1. Set wheel and tire on balancer machine using center hole as a guide. Start balancer machine.

  2. For balancer machines that only have a clip-on (rim flange) weight mode setting, follow this step to calculate correct size adhesive weight to use. When inner and outer imbalance values are shown on balancer machine indicator, multiply outer imbalance value by 5/3 (1.67) to determine balance weight that should be used. Select outer balance weight with a value closest to calculated value above and install into designated outer position of or at designated angle in relation to the wheel and tire.

    • Indicated imbalance value × 5/3 (1.67) = balance weight to be installed

      Calculation example:

      23 g (0.81 oz) × 5/3 (1.67) = 38.33 g (1.35 oz) ⇒ 40 g (1.41 oz) balance weight (closer to calculated balance weight value)

      Example:

      37.4 ⇒ 35 g (1.23 oz)

      37.5 ⇒ 40 g (1.41 oz)

  3. Install balance weight in position shown.

    • When installing balance weight (1) to wheel and tire, set it into grooved area (A) on inner wall of wheel and tire as shown so that balance weight center (B) is aligned with balancer machine indication position (angle) (C).

  4. If calculated balance weight value exceeds 50 g (1.76 oz), install two balance weight sheets in line with each other as shown.

  5. Start balancer machine again.

  6. Install balance weight on inner side of wheel and tire in the balancer machine indication position (angle).

  7. Start balancer machine. Make sure that inner and outer residual imbalance values are 5 g (0.17 oz) each or below.

  8. If either residual imbalance value exceeds 5 g (0.17 oz), repeat installation procedures.

Wheel balanceDynamic (At flange)Static (At flange)
Maximum allowable imbalance Refer to Wheel.
Rotation

Follow maintenance schedule for tire rotation service intervals. Refer to Introduction of Periodic Maintenance.

Rotate wheels and tires front to back in pattern as shown.

When installing wheel, tighten wheel nuts to specified torque. Refer to Exploded View.