Luggage compartment fittings 407sw

1. 12V accessory socket (100 W max.) and luggage compartment light

It is installed on the rear left trim and is powered from the ignition position.

The luggage compartment light is controlled by opening the boot or the tailgate.

2. Storage boxes

There are two side storage boxes which can hold:

• on the left: a bottle of oil, a first-aid kit, a puncture repair aerosol,
• on the right (except with JBL Hi-Fi system): a box of bulbs, a warning triangle (holder provided for this purpose), the luggage retaining net.

3. Luggage cover

To remove it:

• Unclip the front ends and remove the luggage cover.

To refit it:

• Position the front ends of the luggage cover on its supports and press lightly to secure it.

4. Tie-down rings

There are four tie-down rings on the luggage compartment floor for attaching the luggage retaining net.

High-load retaining net

The high-load retaining net can be used behind the front seats (row 1) or behind the rear bench seat (row 2).

Note: when used behind the front seats, the rear seat backs and cushions must be folded down (see the rear seats section).

To refit it:

• fold down the rear seat backs,
• position the high-load retaining net reel above the two rails 5 located behind the rear seats (2/3 bench). The two notches 6 must be positioned above the two rails,
• slide the two rails 5 into the notches 6,

• push the reel (lengthwise) from right to left to lock it,
• refit the rear seat backs.

To use it in row 1:

• fold down the rear seat backs,
• open the covers 7 of the corresponding upper anchorages,
• unroll the high-load retaining net and position one end of the net's metal bar in the corresponding anchorage cover.

  Make sure the hook is properly seated in the rail inside cover 7,

• pull the metal bar of the high-load retaining net to position the other hook in the second anchorage cover.

To use it in row 2:

• open the covers 8 of the corresponding upper anchorages,
• from the rear bench seat, unroll the high-load retaining net, pushing it to release it from the retaining hooks,
• position one end of the net's metal bar in the corresponding anchorage cover.

  Make sure the hook is properly seated in the rail inside cover 8,

• position the other hook in the second anchorage cover and pull the metal bar towards you.