Starter motor

F4R or K4J or K4M

REMOVAL

• Position the vehicle on a two-post lift.
• Disconnect the battery

• Remove:

• the engine covers,
• the air resonator mounting (K4J),
• the air filter outlet duct (K4M), (F4R).

• Disconnect:

• the oil level sensor connector,
• the starter motor connections.

• Remove:

• the exhaust manifold mounting bracket on the gearbox (F4R),
• the starter motor mountings,
• the starter motor.

INSTALLATION

• Check that the centring sleeve is in place.
• Refit in the reverse order of removal.

Connect the battery; carry out the necessary re-learns (see Electrical Equipment chapter).

F9Q

REMOVAL

• Position the vehicle on a two-post lift.
• Disconnect the battery.
• Remove:

• the engine covers,
• the front right wheel,
• the battery,
• the battery tray,
• the air hose between the air filter and the turbocharger duct.

• Remove:

• the air hose (1) and move the hose (2) slightly aside,
• the torque reaction rod,
• the radiator crossmember reinforcement plate on the right-hand side.

• Remove:

• the bracket (3),
• the catalytic converter mounting plate (4) on the gearbox,
• the catalytic converter (5) (Section Exhaust).

• Disconnect the starter motor electrical connections.

• Remove:

• the starter motor mountings (6),
• the starter motor.

INSTALLATION

• Check that the centring sleeve is in place.
• Refit in the reverse order of removal.
• Refit the catalytic converter (Section Exhaust, Catalytic Converter, page 19B-6).

Connect the battery; carry out the necessary re-learns (see Electrical Equipment chapter).

K9K

REMOVAL

• Position the vehicle on a two-post lift.
• Disconnect the battery.
• Remove:

• the engine covers,
• the front right wheel.

• Remove:

• the bracket (1),
• the catalytic converter mounting bracket (2) on the gearbox,
• the catalytic converter (3) (Section Exhaust, Catalytic Converter, page 19B-6).

• Disconnect the starter motor electrical connections.

• Remove:

• the starter motor mountings (4),
• the starter motor (5).

INSTALLATION

• Check that the centring sleeve is in place.
• Refit in the reverse order of removal.
• Refit the catalytic converter (Section Exhaust, Catalytic Converter, page 19B-6).

Connect the battery; carry out the necessary re-learns (see Electrical Equipment chapter).