Subaru Legacy Quiz
Instruments and controls

Canceling the function for meter/gauge needle movement upon turning on the ignition switch

In this manual: Instruments and controls
About vehicle — 35Seat, seatbelt and SRS airbags — 72Keys and doors — 60Instruments and controls — 106Climate control — 43Audio — 92Interior equipment — 38Starting and operating — 85Driving tips — 47In case of emergency — 20Appearance care — 16Maintenance and service — 105Specifications — 16Consumer information and Reporting safety defects — 23
~1min read
It is possible to activate or deactivate the movement of the meter needles and

It is possible to activate or deactivate the movement of the meter needles and gauge needles that takes place when the ignition switch is turned to the “ON” position.

1. Turn the ignition switch to the “LOCK” or “Acc” position.

2. Press the trip knob to show “ ” or “ ” on the trip meter display

The display can be switched as shown in the following illustration by pressing the trip knob.

3. To change the current setting, press the trip knob for at least 2 seconds.

3. To change the current setting, press the trip knob for at least 2 seconds.

: Deactivated: Activated
NOTE: Deactivated


NOTE

● Your vehicle’s initial movement setting of the meter/gauge needles has been set for activation “ ” at the time of shipment from the factory.

● It is not possible to change the initial movement setting of the meter/gauge needles when the ignition switch is in the “ON” position. Change the setting when the ignition switch is in the “LOCK” or “Acc” position.

Test yourself

A quick Subaru Legacy quiz: every answer comes with an explanation and a link to the manual page.