Subaru Legacy Quiz
Instruments and controls

Gear position indicator setting (MT models)

In this manual: Instruments and controls
About vehicle — 35Seat, seatbelt and SRS airbags — 72Keys and doors — 60Instruments and controls — 106Climate control — 43Audio — 92Interior equipment — 38Starting and operating — 85Driving tips — 47In case of emergency — 20Appearance care — 16Maintenance and service — 105Specifications — 16Consumer information and Reporting safety defects — 23
~1min read

The gear position indicator light can be activated or deactivated by performing the following procedure.

1. Turn the ignition switch to the “LOCK” position.

2. Press the trip knob to show “ ” or “ ” on the trip meter display.

The display can be switched as shown in the following illustration by pressing the trip knob.

3. To change the current setting, press the trip knob for at least 2 seconds.

3. To change the current setting, press the trip knob for at least 2 seconds.

NOTE

● The initial setting for your vehicle of the gear position indicator has been set for activation “shipment from the factory.” at the time of
shipment from the factory.

● It is not possible to change the setting of the gear position indicator when the ignition switch is in the “ON” position. Change the setting when the ignition switch is in the “LOCK” or “Acc” position.

Test yourself

A quick Subaru Legacy quiz: every answer comes with an explanation and a link to the manual page.