Installation

1. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

(a) Connect the connector. NOTICE: When handling the airbag connector, take care not to damage the airbag wire harness.

(b) Install the airbag assembly with the 4 bolts.

Torque:

10 N·m {102 kgf·cm, 7 ft·lbf}

2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

3. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH

4. INSTALL COWL SIDE TRIM BOARD LH

5. INSTALL DOOR SCUFF PLATE ASSEMBLY LH

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

7. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light (See page ).