Rear No. 2 Seat Inner Belt Assembly

HINT:

A bolt without a torque specification is shown in the standard bolt chart (See page ).

1. INSTALL REAR NO. 2 SEAT INNER BELT SUB-ASSEMBLY

(a) Using a T45 "TORX" socket wrench, install the inner belt assembly with the bolt.

Torque:

42 N·m {428 kgf·cm, 31 ft·lbf}

2. INSTALL REAR SEAT LOWER CUSHION HINGE COVER RH

3. INSTALL REAR NO. 2 SEAT ASSEMBLY LH

(a) Install the rear No. 2 seat assembly LH (See page ).

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:

• Use the same procedure for the RH and LH sides.
• The procedure listed below is for the LH side.

1. REMOVE REAR NO. 2 SEAT ASSEMBLY LH

(a) Remove the rear No. 2 seat assembly LH (See page ).

2. REMOVE REAR SEAT LOWER CUSHION HINGE COVER RH

3. REMOVE REAR NO. 2 SEAT INNER BELT ASSEMBLY LH

(a) Using a T45 "TORX" socket wrench, remove the bolt and inner belt assembly.