Removal

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

2. REMOVE LOWER NO. 3 STEERING WHEEL COVER

(a) Detach the 2 claws and remove the cover.

3. REMOVE LOWER NO. 2 STEERING WHEEL COVER

(a) Detach the 2 claws and remove the cover. Text in Illustration *A w/o Cruise Control System *B w/ Cruise Control System

4. REMOVE STEERING PAD

(a) Using a T30 "TORX" socket wrench, loosen the 2 screws until the groove along the screw circumference catches on the screw case. Text in Illustration *1 Screw Case

(b) Pull out the steering pad from the steering wheel as shown in the illustration. Then support the steering pad with one hand. NOTICE: When removing the steering pad, do not pull the airbag wire harness.

(c) Disconnect the horn connector.

(d) Disconnect the 2 connectors and remove the steering pad.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.