Toyota Camry Quiz
Ignition

Crankshaft position sensor (2AZ−FE)(From July, 2003)

In this manual: Ignition
Introduction — 61Audio & visual system — 16Automatic transmission / trans — 19Transmission revolution (ATM) — 1Shift lock system (ATM) — 1Brake — 20Clutch — 10Communication system — 4Cooling — 15Cruise control — 3Drive shaft / propeller shaft — 9Emission control — 8Engine control system — 12Engine hood/door — 7Exhaust — 3Exterior/interior trim — 14Front suspension — 9Fuel — 12Heater & air conditioner — 16Ignition — 8Instrument panel/meter — 7Intake — 7Lighting — 11Lubrication — 16Manual transmission/transaxle — 13Parking brake — 10Power steering — 7Rear suspension — 10Seat — 12Service specifications — 26Sliding roof/convertible — 4Starting & charging — 11Starting system (2AZ−FE)(From July, 2003) — 1Starting system (1MZ−FE/3MZ−FE) — 1Steering column — 6Theft deterrent & door lock — 9Tire & wheel — 4Windshield/windowglass/mirror — 5Back window glass — 1Power window control system — 1Power mirror control system — 1Inner rear view mirror assy — 1Windshield glass — 1Wiring — 1
5steps
~30min
2/5difficulty
0102030405097N·mlb·ft
Tightening torque found on this page
Done 0 of 5
REPLACEMENT

HINT: A bolt without torque specification is a standard bolt .

1. REMOVE ENGINE UNDER COVER RH

a. Remove the 5 screws, 3 clips and the under cover.

Remove engine under cover RH Remove engine under cover RH 2. REMOVE FRONT FENDER APRON SEAL RH

a. Remove the clip, 2 bolts and apron seal.

Remove front fender apron seal RH Remove front fender apron seal RH 3. REMOVE CRANKSHAFT POSITION SENSOR
  1. Disconnect the sensor connector.
  2. Remove the bolt, clamp and sensor.
Remove crankshaft position sensor Remove crankshaft position sensor
  1. INSTALL CRANKSHAFT POSITION SENSOR Torque: 9 N·m
  2. INSTALL FRONT FENDER APRON SEAL RH
  3. INSTALL ENGINE UNDER COVER RH

Test yourself

A quick Toyota Camry quiz: every answer comes with an explanation and a link to the manual page.