Toyota Camry Quiz
Seat

Seat belt warning system (From July, 2003)

In this manual: Seat
Introduction — 61Audio & visual system — 16Automatic transmission / trans — 19Transmission revolution (ATM) — 1Shift lock system (ATM) — 1Brake — 20Clutch — 10Communication system — 4Cooling — 15Cruise control — 3Drive shaft / propeller shaft — 9Emission control — 8Engine control system — 12Engine hood/door — 7Exhaust — 3Exterior/interior trim — 14Front suspension — 9Fuel — 12Heater & air conditioner — 16Ignition — 8Instrument panel/meter — 7Intake — 7Lighting — 11Lubrication — 16Manual transmission/transaxle — 13Parking brake — 10Power steering — 7Rear suspension — 10Seat — 12Service specifications — 26Sliding roof/convertible — 4Starting & charging — 11Starting system (2AZ−FE)(From July, 2003) — 1Starting system (1MZ−FE/3MZ−FE) — 1Steering column — 6Theft deterrent & door lock — 9Tire & wheel — 4Windshield/windowglass/mirror — 5Back window glass — 1Power window control system — 1Power mirror control system — 1Inner rear view mirror assy — 1Windshield glass — 1Wiring — 1
23steps
~138min
4/5difficulty
Done 0 of 23
PROBLEM SYMPTOMS TABLE
Symptom Suspected Area
Driver side seat belt warning light does not blink, or it does not go off after the seat belt is fastened when the ignition switch is on.
  1. IG1 relay
  2. AM1 fuse
  3. GAUGE1 fuse
  4. Front seat inner belt assy LH
  5. Combination meter
  6. Wire harness
Passenger side seat belt warning light does not blink with the front passenger’s seat occupied, or it does not go off after the seat belt is fastened when the ignition switch is on.
  1. IG1 relay
  2. AM1 fuse
  3. GAUGE1 fuse
  4. Clock
  5. Front seat inner belt assy RH
  6. Occupant classification ECU
  7. Occupant classification sensor
  8. Airbag sensor assy
  9. Wire harness
NOTICE: The front seat inner belt RH can not be inspected. When the front seat inner belt seems to be malfunctioning, using the hand−held tester to check the DTC. INSPECTION 1. TMMK made: INSPECT FRONT SEAT INNER BELT ASSY LH

a. Check the buckle switch.

  1. Fasten the seat belt.

  2. Check the resistance between the terminals.

Standard

:

  1. Release the seat belt.

  2. Check the resistance between the terminals.

    Standard:

    If the result is not as specified, replace the inner belt assy.

If the result is not as specified, replace the inner belt assy.

Inspect front seat inner belt assy LH
2. TMC made: INSPECT FRONT SEAT INNER BELT ASSY LH

a. Check the buckle switch.

  1. Fasten the seat belt.

  2. Check the resistance between the terminals.

Standard

:

  1. Release the seat belt.

  2. Check the resistance between the terminals.

Standard

:

If the result is not as specified, replace the inner belt assy.

If the result is not as specified, replace the inner belt assy.

Inspect front seat inner belt assy LH

Test yourself

A quick Toyota Camry quiz: every answer comes with an explanation and a link to the manual page.