Engine & Hybrid System

Crankshaft Position Sensor

~2min read
01020304050107N·mlb·ft
Tightening torque found on this page

Removal

REMOVAL

COMPONENTS (REMOVAL)

Procedure

Part Name Code

1

NO. 1 ENGINE UNDER COVER ASSEMBLY

51410

-

-

-

2

CRANKSHAFT POSITION SENSOR

11401G

-

-

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click here

PROCEDURE

1. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY

Click here

2. REMOVE CRANKSHAFT POSITION SENSOR

(1) Disconnect the crank position sensor connector.

(2) Using an 8 mm socket wrench, remove the bolt and crank position sensor from the cylinder block sub-assembly.

NOTICE:

If the crank position sensor has been struck or dropped, replace it.

Installation

INSTALLATION

COMPONENTS (INSTALLATION)

Procedure

Part Name Code

1

CRANKSHAFT POSITION SENSOR

11401G

-

-

2

NO. 1 ENGINE UNDER COVER ASSEMBLY

51410

-

-

-

TOYOTA genuine engine oil

-

-

Tightening torque for "Major areasinvolving basic vehicle performance suchas moving/turning/stopping" : N*m(kgf*cm, ft.*lbf)

N*m (kgf*cm, ft.*lbf): Specified torque

NOTICE:

This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click here

PROCEDURE

1. INSTALL CRANKSHAFT POSITION SENSOR

(1) Apply a light coat of engine oil to the O-ring of the crank position sensor.

NOTICE:

If reusing the crank position sensor, be sure to inspect the O-ring.

(2) Using an 8 mm socket wrench, install the crank position sensor to the cylinder block sub-assembly with the bolt.

Torque:

10 N·m {102 kgf·cm, 7 ft·lbf}

NOTICE:

  • If the crank position sensor has been struck or dropped, replace it.
  • Make sure that the O-ring is not cracked or moved out of place when installing the crank position sensor.

(3) Connect the crank position sensor connector.

2. INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY

Click here