Power Source & Network

Data List / Active Test

~2min read

DATA LIST / ACTIVE TEST

NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

HINT:

Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

DATA LIST

(a) Read the Data List.

Body Electrical > Central Gateway > Data List

Tester Display

Total Distance Traveled

Total Distance Traveled - Unit

IG2 SW/IGR SW

IG1 SW/IGP SW

ACC SW

+B Voltage

Body Electrical > Central Gateway > Data List

Tester Display

Measurement Item

Range

Normal Condition

Total Distance Traveled

Total distance traveled

Min.: 0 km (0 mile), Max.: 16777215 km (10425361 mile)

-

Total Distance Traveled - Unit

Total Distance Traveled unit

km or mile

-

IG2 SW/IGR SW

Ignition switch ON signal (IGR terminal)

OFF or ON

OFF: Ignition switch ACC or off

ON: Ignition switch ON

IG1 SW/IGP SW

Ignition switch ON signal (IGP terminal)

OFF or ON

OFF: Ignition switch ACC or off

ON: Ignition switch ON

ACC SW

Ignition switch ACC signal (ACC terminal)

OFF or ON

OFF: Ignition switch off

ON: Ignition switch ACC or ON

+B Voltage

Auxiliary battery voltage (BATT terminal)

Over 8 V or Under 8 V

Over 8 V: Auxiliary battery voltage 8 V or higher

Under 8 V: Auxiliary battery voltage below 8 V