How To Proceed With Troubleshooting
HINT:
*: Use the GTS.
PROCEDURE
VEHICLE BROUGHT TO WORKSHOP
|
CUSTOMER PROBLEM ANALYSIS
(a) Interview the customer and confirm the problem.
Click here ![]()
|
INSPECT AUXILIARY BATTERY VOLTAGE
Standard Voltage:
11 to 14 V
- If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding to the next step.
|
CHECK DTC AND FREEZE FRAME DATA*
(a) Check and record DTCs and freeze frame data.
Chassis > Brake/EPB > Trouble Codes(b) Clear the DTCs and freeze frame data.
Chassis > Brake/EPB > Clear DTCs(c) Recheck for DTCs.
(1) Reconfirm the DTCs based on the recorded DTCs and freeze frame data.
Chassis > Brake/EPB > Trouble Codes(2) Try to reproduce the problem symptoms based on the recorded DTCs and freeze frame data, and then check if the DTCs are output again.
Result | Proceed to |
|---|---|
DTCs are not output (Problem symptom occurs.) |
A |
DTCs are output |
B |
DTCs are not output (Problem symptom does not occur.) |
C |
HINT:
- Refer to Diagnostic Trouble Code Chart if any DTCs are output.
- When DTCs indicating a CAN communication system malfunction are output, first troubleshoot and repair the CAN communication system.
| B | GO TO DIAGNOSTIC TROUBLE CODE CHART |
| C | USE SIMULATION METHOD TO CHECK |
|
PROBLEM SYMPTOMS TABLE
(a) Proceed to Problem Symptoms Table.
Click here ![]()
Result | Proceed to |
|---|---|
Fault is not listed in Problem Symptoms Table |
A |
Fault is listed in Problem Symptoms Table |
B |
| B | GO TO STEP 7 |
|
OVERALL ANALYSIS AND TROUBLESHOOTING*
(a) Refer to Terminals of ECU.
Click here ![]()
(b) Refer to Data List / Active Test.
Click here ![]()
|
REPAIR OR REPLACE
|
CONFIRMATION TEST
| NEXT | END |