INSPECTION
PROCEDURE
1. INSPECT ELECTRIC PARKING BRAKE SWITCH ASSEMBLY
(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
7 (SWI1) - 8 (SWO1) |
OFF (Release) |
100 kΩ or higher |
7 (SWI1) - 8 (SWO1) |
ON (Lock) |
10 Ω or less |
7 (SWI1) - 8 (SWO1) |
Switch not operated |
100 kΩ or higher |
7 (SWI1) - 1 (SWI2) |
OFF (Release) |
10 Ω or less |
7 (SWI1) - 1 (SWI2) |
ON (Lock) |
10 Ω or less |
7 (SWI1) - 1 (SWI2) |
Switch not operated |
100 kΩ or higher |
7 (SWI1) - 2 (SWO2) |
OFF (Release) |
10 Ω or less |
7 (SWI1) - 2 (SWO2) |
ON (Lock) |
100 kΩ or higher |
7 (SWI1) - 2 (SWO2) |
Switch not operated |
10 Ω or less |
1 (SWI2) - 8 (SWO1) |
OFF (Release) |
100 kΩ or higher |
1 (SWI2) - 8 (SWO1) |
ON (Lock) |
10 Ω or less |
1 (SWI2) - 8 (SWO1) |
Switch not operated |
10 Ω or less |
1 (SWI2) - 2 (SWO2) |
OFF (Release) |
10 Ω or less |
1 (SWI2) - 2 (SWO2) |
ON (Lock) |
100 kΩ or higher |
1 (SWI2) - 2 (SWO2) |
Switch not operated |
100 kΩ or higher |
|
 |
*a |
Component without harness connected
(Electric Parking Brake Switch Assembly) |
|
|
(2) If the result is not as specified, replace the electric parking brake switch assembly.
(b) Check the Illumination.
(1) Apply auxiliary battery voltage to the electric parking brake switch assembly and check that the switch illuminates.
OK:
Tester Connection | Specified Condition |
Auxiliary battery positive (+) → 3 (IND+)
Auxiliary battery negative (-) → 5 (IND-) |
Illuminates |
|
 |
*a |
Component without harness connected
(Electric Parking Brake Switch Assembly) |
|
|
(2) If the result is not as specified, replace the electric parking brake switch assembly.
Was this page helpful?