Vehicle Exterior

Inspection

~1min read

INSPECTION

PROCEDURE

1. INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY

(a) Check that the resistance.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

I38-6 (TB) - I38-3 (E)

Hazard warning switch off

10 kΩ or higher

I38-6 (TB) - I38-3 (E)

Hazard warning switch on

Below 50 Ω

If the result is not as specified, replace the hazard warning signal switch assembly.

*a

Component without harness connected

(Hazard Warning Signal Switch Assembly)

(b) Check that the illumination lights.

(1) Apply auxiliary battery voltage to the hazard warning signal switch assembly and check that the switch illumination lights comes on.

OK:

Measurement Condition

Condition

Specified Condition

I38-7 (ILL+) - Auxiliary battery positive (+)

I38-2 (ILL-) - Auxiliary battery negative (-)

Always

Switch illumination lights comes on

If the result is not as specified, replace the hazard warning signal switch assembly.

*a

Component without harness connected

(Hazard Warning Signal Switch Assembly)