Vehicle Exterior
Inspection
INSPECTION
PROCEDURE
1. INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY (for LH Side)
(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
N3-5 (UP) - N3-7 (GND) |
Auto up or up position |
Below 100 Ω |
N3-4 (DOWN) - N3-7 (GND) |
Auto down or down position |
Below 100 Ω |
N3-8 (AUTO) - N3-7 (GND) |
Auto up or auto down position |
Below 100 Ω |
N3-5 (UP) - N3-7 (GND) |
Off |
10 kΩ or higher |
N3-4 (DOWN) - N3-7 (GND) |
Off |
10 kΩ or higher |
N3-8 (AUTO) - N3-7 (GND) |
Off |
10 kΩ or higher |
If the result is not as specified, replace the rear power window regulator switch assembly. |
 |
*a |
Component without harness connected
(Rear Power Window Regulator Switch Assembly) |
|
|
2. INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY (for RH Side)
(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
M3-5 (UP) - M3-7 (GND) |
Auto up or up position |
Below 100 Ω |
M3-4 (DOWN) - M3-7 (GND) |
Auto down or down position |
Below 100 Ω |
M3-8 (AUTO) - M3-7 (GND) |
Auto up or auto down position |
Below 100 Ω |
M3-5 (UP) - M3-7 (GND) |
Off |
10 kΩ or higher |
M3-4 (DOWN) - M3-7 (GND) |
Off |
10 kΩ or higher |
M3-8 (AUTO) - M3-7 (GND) |
Off |
10 kΩ or higher |
If the result is not as specified, replace the rear power window regulator switch assembly. |
 |
*a |
Component without harness connected
(Rear Power Window Regulator Switch Assembly) |
|
|
Was this page helpful?