Vehicle Interior
Inspection
INSPECTION
PROCEDURE
1. INSPECT LIGHT CONTROL RHEOSTAT
(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
I228-4 (RV) - I228-2 (E) |
Light control rheostat knob fully downwards (MIN.) |
Below 50 Ω |
I228-4 (RV) - I228-2 (E) |
Light control rheostat knob between MIN. and MAX. |
The value changes gradually (Between 0 to 12 kΩ) |
I228-4 (RV) - I228-2 (E) |
Light control rheostat knob fully upwards (MAX.) |
8 to 12 kΩ |
I228-3 (TC) - I228-2 (E) |
Light control rheostat knob not fully upward |
8 to 12 kΩ |
I228-3 (TC) - I228-2 (E) |
Light control rheostat knob fully upwards (Tail cancel switch is on) |
1 MΩ or higher |
If the result is not as specified, replace the light control rheostat. |
 |
*a |
Component without harness connected
(Light Control Rheostat) |
|
|
(b) Check the illumination.
(1) Apply auxiliary battery voltage to the light control rheostat and check that it illuminates.
OK:
Tester Connection | Specified Condition |
I228-6 (ILL+) - Auxiliary battery positive (+)
I228-1 (ILL-) - Auxiliary battery negative (-) |
Illuminates |
If the result is not as specified, replace the light control rheostat. |
 |
*a |
Component without harness connected
(Light Control Rheostat) |
|
|
Was this page helpful?