Vehicle Interior
Inspection
INSPECTION
PROCEDURE
1. INSPECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY
(a) for LH Belt:
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
O85-5(LBR+) - O85-4(LBR-) |
Rear LH seat belt unfastened |
Below 1 Ω |
Rear LH seat belt fastened |
10 kΩ or higher |
If the result is not as specified, replace the rear seat inner with center belt assembly. |
 |
*a |
Component without harness connected
(Rear Seat Inner with Center Belt Assembly) |
|
|
(b) for Center Belt:
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
O86-1(CBR+) - O86-2(CBR-) |
Rear center seat belt unfastened |
Below 1 Ω |
Rear center seat belt fastened |
10 kΩ or higher |
If the result is not as specified, replace the rear seat inner with center belt assembly. |
 |
*a |
Component without harness connected
(Rear Seat Inner with Center Belt Assembly) |
|
|
Was this page helpful?