Vehicle Interior

Inspection

~1min read

INSPECTION

PROCEDURE

1. INSPECT FRONT SEAT INNER BELT ASSEMBLY (for Driver Side)

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

O49-3(+) - O49-2(-)

Driver side seat belt unfastened

Below 1 Ω

Driver side seat belt fastened

10 kΩ or higher

If the result is not as specified, replace the front seat inner belt assembly.

*a

Component without harness connected

(Front Seat Inner Belt Assembly)

2. INSPECT FRONT SEAT INNER BELT ASSEMBLY (for Front Passenger Side)

(a) Measure the resistance according to the value(s) in the table below (seat belt warning switch).

Standard Resistance:

Tester Connection

Condition

Specified Condition

j15-3(+) - j15-2(E)

Front passenger side seat belt unfastened

Below 1 Ω

Front passenger side seat belt fastened

10 kΩ or higher

If the result is not as specified, replace the front seat inner belt assembly.

*a

Component without harness connected

(Front Seat Inner Belt Assembly)

(b) Measure the resistance according to the value(s) in the table below (occupant detection sensor line).

Standard Resistance:

Tester Connection

Condition

Specified Condition

j15-5(+) - A-1

Always

Below 1 Ω

j15-4(E) - A-3

Always

Below 1 Ω

If the result is not as specified, replace the front seat inner belt assembly.