Vehicle Interior
Inspection
In this manual: Vehicle Interior
~1min read
INSPECTION
PROCEDURE
1. INSPECT REAR SEAT BELT ASSEMBLY OUTER
(a) Before installing the rear 3 point type seat outer belt assembly, check the ELR function. NOTICE: Do not disassemble the retractor. (1) When the inclination of the retractor is 15° or less, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45°, check that the belt locks. If the result is not as specified, replace the rear 3 point type seat outer belt assembly. |
|
Was this page helpful?
