Installation
INSTALLATION
COMPONENTS (INSTALLATION)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
TIMING CHAIN COVER OIL SEAL |
11301C |
- |
- |
|
2 |
CRANKSHAFT PULLEY ASSEMBLY |
13470 |
- |
- |
|
3 |
V-RIBBED BELT |
16361A |
- |
- |
|
4 |
INSPECT FOR ENGINE OIL LEAK |
- |
- |
- |
|
5 |
REAR ENGINE UNDER COVER RH |
51443C |
- |
- |
- |
6 |
NO. 1 ENGINE UNDER COVER ASSEMBLY |
51410 |
- |
- |
- |
7 |
FRONT WHEEL RH |
- |
- |
- |
- |
![]() |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |
![]() |
N*m (kgf*cm, ft.*lbf): Specified torque |
● |
Non-reusable part |
- |
- |
PROCEDURE
1. INSTALL TIMING CHAIN COVER OIL SEAL
*a |
0 to 2 mm |
- |
- |
(1) Apply MP grease to the lip of a new timing chain cover oil seal.
NOTICE:
- Keep the lip free from foreign matter.
- Do not allow MP grease to contact the dust seal.
(2) Using SST and a hammer, tap in the timing chain cover oil seal.
SST: 09223-00010
Standard Depth:
0 to 2 mm (0 to 0.0787 in.) (From the edge of the No. 2 timing chain cover assembly)
NOTICE:
Do not tap in the timing chain cover oil seal at an angle.
2. INSTALL CRANKSHAFT PULLEY ASSEMBLY
![]() |
Click here |
3. INSTALL V-RIBBED BELT
![]() |
Click here |
4. INSPECT FOR ENGINE OIL LEAK
Click here ![]()
5. INSTALL REAR ENGINE UNDER COVER RH
Click here ![]()
6. INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY
Click here ![]()
7. INSTALL FRONT WHEEL RH
Click here ![]()
.png)
.png)
.png)
.gif)
.png)
.png)