Power Source & Network
LIN Communication Missing Message (B228787)
In this manual: Power Source & Network
~1min read
DESCRIPTION
When an internal malfunction is detected in the certification ECU (smart key ECU assembly), this DTC is stored.
DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
B228787 |
LIN Communication Missing Message |
An internal malfunction occurs in the certification ECU (smart key ECU assembly). |
Certification ECU (smart key ECU assembly) |
NOTICE:
- When using the GTS with the ignition switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Smart Key(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.
- Before replacing the certification ECU (smart key ECU assembly), refer to Registration.
- for HEV Model: Click here
.gif)
- for Gasoline Model: Click here
.gif)
- for HEV Model: Click here
PROCEDURE
CHECK FOR DTC
(a) Check for DTCs.
Body Electrical > Smart Key > Trouble CodesResult | Proceed to |
|---|---|
B278588 is output |
A |
B278588 is not output |
B |
| A | GO TO DTC CHART |
|
CLEAR DTC
(a) Clear the DTCs.
Body Electrical > Power Source Control > Clear DTCs
|
CHECK FOR DTC
(a) Check for DTCs.
Body Electrical > Power Source Control > Trouble CodesResult | Proceed to |
|---|---|
B228787 is output |
A |
B228787 is not output |
B |
| A | REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) |
| B | USE SIMULATION METHOD TO CHECK |
Was this page helpful?