Drivetrain

Oil Pressure Sensor

2steps
~12min
2/5difficulty
0102030405020.615N·mlb·ft
Tightening torque found on this page
Done 0 of 2

Removal

REMOVAL

COMPONENTS (REMOVAL)

Procedure

Part Name Code

1

OIL PRESSURE SENSOR

89637K

-

-

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the oil pressure sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced

Replacement Part or Procedure

Necessary Procedures

Effect/Inoperative Function When Necessary Procedures are not Performed

Link

Oil pressure sensor

  1. Reset memory
  2. CVT oil pressure calibration

Deterioration of fuel efficiency

PROCEDURE

1. REMOVE OIL PRESSURE SENSOR

(1) Disconnect the oil pressure sensor connector.

(2) Using a 27 mm deep socket wrench, remove the oil pressure sensor from the rear transaxle case sub-assembly.

Installation

INSTALLATION

Procedure

Part Name Code

1

OIL PRESSURE SENSOR

89637K

-

-

2

INSPECT FOR CONTINUOUSLY VARIABLE TRANSAXLE FLUID LEAK

-

-

-

3

RESET MEMORY

-

-

-

N*m (kgf*cm, ft.*lbf): Specified torque

Toyota Genuine CVT Fluid FE

PROCEDURE

1. INSTALL OIL PRESSURE SENSOR

Toyota Genuine CVT fluid FE

-

-

(1) Coat the O-ring of the oil pressure sensor with Toyota Genuine CVT fluid FE.

NOTICE:

If reusing the oil pressure sensor, check that the O-ring is not damaged.

(2) Using a 27 mm deep socket wrench, install the oil pressure sensor to the rear transaxle case sub-assembly.

Torque:

21 N·m {210 kgf·cm, 15 ft·lbf}

NOTICE:

Be careful not to damage the O-ring.

(3) Connect the oil pressure sensor connector.

2. INSPECT FOR CONTINUOUSLY VARIABLE TRANSAXLE FLUID LEAK

Click here

3. RESET MEMORY

NOTICE:

If continuously variable transaxle parts have been replaced, refer to Parts Replacement Compensation Table to determine if any additional operations are necessary.

Click here