Engine & Hybrid System

On-vehicle Inspection

~1min read

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT ACCELERATOR PEDAL(W/SENSOR) ROD ASSEMBLY

(a) Connect the GTS to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the GTS on.

(d) Enter the following menus: Powertrain / Engine / Data List / Accelerator Position Sensor No.1 Voltage and Accelerator Position Sensor No.2 Voltage.

Powertrain > Engine > Data List

Tester Display

Accelerator Position Sensor No.1 Voltage

Accelerator Position Sensor No.2 Voltage

(e) Read the values displayed on the GTS.

Standard Voltage:

GTS Display

Condition

Specified Condition

Accelerator Position Sensor No.1 Voltage

Accelerator pedal fully released

0.5 to 1.1 V

Accelerator pedal fully depressed

2.6 to 4.5 V

Accelerator Position Sensor No.2 Voltage

Accelerator pedal fully released

1.2 to 2.0 V

Accelerator pedal fully depressed

3.4 to 4.75 V

If the result is not as specified, check the accelerator pedal sensor assembly, wire harness and ECM.