Engine & Hybrid System
Relay
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT FAN NO. 1 RELAY
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
3 - 5 |
Auxiliary battery voltage not applied between terminals 1 and 2 |
10 kΩ or higher |
3 - 5 |
Auxiliary battery voltage applied between terminals 1 and 2 |
Below 1 Ω |
|
 |
(b) If the result is not as specified, replace the FAN NO. 1 relay.
2. INSPECT FAN NO. 2 RELAY
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
3 - 4 |
Auxiliary battery voltage not applied between terminals 1 and 2 |
Below 1 Ω |
3 - 4 |
Auxiliary battery voltage applied between terminals 1 and 2 |
10 kΩ or higher |
3 - 5 |
Auxiliary battery voltage not applied between terminals 1 and 2 |
10 kΩ or higher |
3 - 5 |
Auxiliary battery voltage applied between terminals 1 and 2 |
Below 1 Ω |
|
 |
(b) If the result is not as specified, replace the FAN NO. 2 relay.
3. INSPECT FAN NO. 3 RELAY
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
3 - 5 |
Auxiliary battery voltage not applied between terminals 1 and 2 |
10 kΩ or higher |
3 - 5 |
Auxiliary battery voltage applied between terminals 1 and 2 |
Below 1 Ω |
|
 |
(b) If the result is not as specified, replace the FAN NO. 3 relay.
Was this page helpful?