ADAS & AD
Removal
In this manual: ADAS & AD
~1min read
REMOVAL
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are replaced during millimeter wave radar sensor assembly removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/ReplacedReplaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
Millimeter wave radar sensor assembly |
Adjust millimeter wave radar sensor assembly |
|
Triangle Target: Flat Surface Target: Driving Adjustment: |
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
MILLIMETER WAVE RADAR SENSOR ASSEMBLY |
88211B |
- |
- |
|
PROCEDURE
1. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY
![]() |
NOTICE: Do not reuse the millimeter wave radar sensor assembly if it has been dropped or subjected to a severe impact. |
![]() |
Bolt |
![]() |
Screw |
Was this page helpful?
.gif)
.png)
.png)
.png)
.png)
