Removal
REMOVAL
COMPONENTS (REMOVAL)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
NO. 1 ENGINE UNDER COVER ASSEMBLY |
51410 |
- |
- |
- |
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
2 |
NO. 1 INVERTER COOLING OUTLET HOSE |
G922C |
- |
- |
|
3 |
NO. 2 INVERTER COOLING OUTLET HOSE |
G922D |
- |
- |
|
4 |
MOTOR COOLING COOLER |
G125AA |
- |
- |
|
● |
Non-reusable part |
- |
- |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during motor cooling cooler removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/ReplacedReplaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
Replacement of inverter with converter assembly |
Resolver learning |
|
CAUTION:
- This vehicle has contains high voltage circuits standardized with orange colored wiring and connectors, so follow the instructions in this manual to perform the procedures correctly.
Click here
.gif)
- If the correct procedures are not followed according to the instructions in this manual, there is a danger of electric shock from the high voltage circuits.
- Be sure to wear insulating gloves when working on high voltage wiring or components.
.png)
- If work is performed without wearing insulating gloves, there is a danger of electric shock.
HINT:
When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
- Learning completes when vehicle is driven
Effect/Inoperative Function When Necessary Procedures are not Performed
Necessary Procedures
Link
Front Camera System
Drive the vehicle straight ahead at 15 km/h or more for 5 second or more.
.gif)
- Learning completes when vehicle is operated normally
Effect/Inoperative Function When Necessary Procedures are not Performed
Necessary Procedures
Link
Power door lock control system
- Back door opener
Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch.
.gif)
Power back door system
Fully close the back door by hand.
HINT:
Initialization is not necessary if the above procedures are performed while the back door is closed.
.gif)
Air conditioning system
After the ignition switch is turned to ON, the servo motor standard position is recognized.
-
PROCEDURE
1. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY
Click here ![]()
2. REMOVE NO. 1 INVERTER COOLING OUTLET HOSE
![]() |
HINT: After disconnecting the motor cooling hoses, in order to prevent the scattering of the coolant into the surrounding parts and the contamination of foreign matter into the coolant path, the cooling pipes and the hoses are plugged with a hose plug or wrapped in a plastic bag etc. |
3. REMOVE NO. 2 INVERTER COOLING OUTLET HOSE
![]() |
HINT: After disconnecting the motor cooling hoses, in order to prevent the scattering of the coolant into the surrounding parts and the contamination of foreign matter into the coolant path, the cooling pipes and the hoses are plugged with a hose plug or wrapped in a plastic bag etc. |
4. REMOVE MOTOR COOLING COOLER
(1) Remove the 3 bolts and motor cooling cooler from the hybrid vehicle transaxle assembly.
(2) Remove the 2 O-rings.
.png)
.png)
.png)