Removal
REMOVAL
COMPONENTS (REMOVAL)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
WIRING HARNESS CLAMP BRACKET |
82715W |
- |
- |
|
2 |
NO. 2 AIR FUEL RATIO SENSOR |
89467C |
- |
- |
|
*A |
for 2WD |
*B |
for AWD |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during air fuel ratio sensor removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/ReplacedReplaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
|
Inspection after repair |
|
PROCEDURE
1. REMOVE WIRING HARNESS CLAMP BRACKET (for 2WD)
![]() |
CAUTION: To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot. |
2. REMOVE NO. 2 AIR FUEL RATIO SENSOR
![]() |
CAUTION: To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot. NOTICE: If the air fuel ratio sensor has been struck or dropped, replace it. |
(a) for 2WD:
(1) Disconnect the air fuel ratio sensor connector.
(2) Disengage the wire harness clamp.
(3) Using SST, remove the No. 2 air fuel ratio sensor from the front exhaust pipe assembly (TWC: Rear Catalyst).
SST: 09224-00012
(b) for AWD:
(1) Disconnect the air fuel ratio sensor connector.
(2) Disengage the wire harness clamp.
(3) Using SST, remove the No. 2 air fuel ratio sensor from the front exhaust pipe assembly (TWC: Rear Catalyst).
SST: 09224-00012
.png)
.png)
.png)
.gif)