Removal
REMOVAL
COMPONENTS (REMOVAL)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
DRAIN ENGINE COOLANT |
- |
- |
- |
|
2 |
VACUUM SWITCHING VALVE ASSEMBLY |
25860 |
- |
- |
- |
3 |
AIR CLEANER CAP WITH AIR CLEANER HOSE |
- |
- |
- |
- |
4 |
NO. 8 WATER BY-PASS HOSE |
16296 |
- |
- |
- |
5 |
THROTTLE BODY WITH MOTOR ASSEMBLY |
22030 |
- |
- |
- |
6 |
NO. 5 WATER BY-PASS HOSE |
- |
- |
- |
|
7 |
THROTTLE BODY GASKET |
22271 |
- |
- |
- |
● |
Non-reusable part |
- |
- |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during throttle body with motor assembly removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/ReplacedReplaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
|
Inspection after repair |
|
NOTICE:
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click here
![]()
PROCEDURE
1. DRAIN ENGINE COOLANT
Click here ![]()
2. REMOVE VACUUM SWITCHING VALVE ASSEMBLY
3. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE
*a |
Wire Harness Clamp |
*b |
Clamp |
*c |
Guide |
- |
- |
4. DISCONNECT NO. 8 WATER BY-PASS HOSE
5. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY
6. DISCONNECT NO. 5 WATER BY-PASS HOSE
![]() |
NOTICE: If the throttle body with motor assembly has been struck or dropped, replace it. |
7. REMOVE THROTTLE BODY GASKET

.png)
.png)
.png)
.gif)