Removal
REMOVAL
COMPONENTS (REMOVAL)
Procedure |
Part Name Code |
![]() |
![]() |
![]() |
|
1 |
TIMING CHAIN COVER ASSEMBLY |
11310 |
- |
- |
- |
2 |
OIL PAN SUB-ASSEMBLY |
12101 |
- |
- |
|
3 |
OIL STRAINER SUB-ASSEMBLY |
15104 |
- |
- |
|
4 |
OIL PUMP ASSEMBLY |
15100 |
- |
- |
- |
● |
Non-reusable part |
- |
- |
NOTICE:
- After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
- This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click here
.gif)
HINT:
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
- Learning completes when vehicle is driven.
Effect/Inoperative Function When Necessary Procedures are not Performed
Necessary Procedures
Link
Front camera system
Drive the vehicle straight ahead at 15 km/h or more for 1 second or more.
.gif)
Stop and start system
Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)
.gif)
- Learning completes when vehicle is operated normally
Effect/Inoperative Function When Necessary Procedures are not Performed
Necessary Procedures
Link
Power door lock control system
- Back door opener
Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch.
.gif)
Power back door system
Fully close the back door by hand.
HINT:
Initialization is not necessary if the above procedures are performed while the back door is closed.
.gif)
Air conditioning system
After the ignition switch is turned to ON, the servo motor standard position is recognized.
-
PROCEDURE
1. REMOVE TIMING CHAIN COVER ASSEMBLY
Click here ![]()
2. REMOVE OIL PAN SUB-ASSEMBLY
![]() |
Click here |
3. REMOVE OIL STRAINER SUB-ASSEMBLY
![]() |
Click here |
4. REMOVE OIL PUMP ASSEMBLY

.png)
.png)
.png)