Vehicle Exterior
Removal
In this manual: Vehicle Exterior
~1min read
REMOVAL
COMPONENTS (REMOVAL)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
REAR WHEEL HOUSE FRONT PLATE |
65632D |
- |
- |
- |
2 |
QUARTER OUTSIDE MOULDING SUB-ASSEMBLY |
75606B |
- |
- |
|
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. REMOVE REAR WHEEL HOUSE FRONT PLATE
Click here ![]()
2. REMOVE QUARTER OUTSIDE MOULDING SUB-ASSEMBLY
![]() |
Push |
![]() |
Place Hand Here |
![]() |
Remove in this Direction (1) |
![]() |
Remove in this Direction (2) |
(1) Remove the 4 clips and screw.
(2) Apply protective tape around the quarter outside moulding sub-assembly as shown in the illustration.
(3) Disengage the claws by pushing the area indicated by the arrow in the illustration with a finger.
NOTICE:
To avoid damaging the claws, do not forcibly pull the quarter outside moulding sub-assembly.
(4) Disengage the clips to remove the quarter outside moulding sub-assembly as shown in the illustration.
Was this page helpful?
.png)
.png)
.png)
.gif)
.png)
.png)
.png)
.png)