Removal
REMOVAL
COMPONENTS (REMOVAL)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
HEADLIGHT ASSEMBLY |
- |
- |
- |
- |
2 |
HEADLIGHT ECU SUB-ASSEMBLY |
- |
- |
- |
|
*1 |
HEADLIGHT UNIT ASSEMBLY |
- |
- |
● |
Non-reusable part |
- |
- |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during headlight ECU sub-assembly removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/ReplacedReplaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function When Necessary Procedures are not Performed | Link |
|---|---|---|---|
Headlight ECU sub-assembly LH |
|
Automatic headlight beam level control system |
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. REMOVE HEADLIGHT ASSEMBLY
Click here
![]()
2. REMOVE HEADLIGHT ECU SUB-ASSEMBLY
![]() |
NOTICE: Make sure to replace the headlight ECU sub-assembly with a new one. Failure to do so may cause water ingress. |
SST: 09890-47010
09891-04010
09891-04020
09891-04030
09891-04040

.png)
.png)
.png)
.gif)