Vehicle Exterior

Removal

~1min read

REMOVAL

COMPONENTS (REMOVAL)

Procedure

Part Name Code

1

REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

89408C

-

-

2

REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

89408C

-

-

*A

for 2WD

*B

for AWD

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the height control sensor sub-assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced

Replaced Part or Performed Procedure

Necessary Procedure

Effect/Inoperative Function when Necessary Procedure not Performed

Link

Rear height control sensor sub-assembly LH

Initialize headlight ECU sub-assembly LH

Automatic headlight beam level control system

PROCEDURE

1. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (for 2WD)

NOTICE:

If the rear height control sensor sub-assembly LH has been struck or dropped, replace it with a new one.

2. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (for AWD)

NOTICE:

If the rear height control sensor sub-assembly LH has been struck or dropped, replace it with a new one.