Removal
REMOVAL
COMPONENTS (REMOVAL)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
FRONT SEAT ASSEMBLY |
- |
- |
- |
- |
2 |
SEPARATE TYPE FRONT SEATBACK COVER |
71073S |
- |
- |
- |
3 |
FRONT SEAT INNER BELT ASSEMBLY |
73230 |
- |
- |
- |
*A |
for Driver Side Manual Seat |
*B |
for Driver Side Power Seat |
*C |
for Front Passenger Seat |
- |
- |
*1 |
Front Seat Belt Anchor Plate |
- |
- |
CAUTION:
Be sure to read Precaution thoroughly before servicing.
Click here ![]()
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the front seat inner belt assembly removal/installation are shown below.
HINT:
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
- Learning completes when vehicle is driven
Effect / Inoperative Function When Necessary Procedures are not Performed
Necessary Procedures
Link
*A: for Gasoline Model Front Camera System
Drivre the vehicle straight ahead at 15 km/h or more for 1 second or more.
.gif)
Stop and start system *A
Drive the vehicle until stop and start control is permitted (appoximately 5 to 60 minutes)
.gif)
- Learning completes when vehicle is operated normally
Effect / Inoperative Function When Necessary Procedures are not Performed
Necessary Procedures
Link
Power door lock control system
- Back door opener
Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch.
.gif)
Power back door system
Fully close the back door by hand.
HINT:
Initialization is not necessary if the above procedures are performed while the back door is closed.
.gif)
Air conditioning system
After the ignition switch is turned to ON, the servo motor standard position is recognized.
-
PROCEDURE
1. REMOVE FRONT SEAT ASSEMBLY
![]() |
|
2. DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER
HINT:
Use the same procedure as for the driver side.
Click here ![]()
3. REMOVE FRONT SEAT INNER BELT ASSEMBLY
(a) for Driver Side Manual Seat:
(b) for Driver Side Power Seat:
(c) for Front Passenger Side:

.png)
.png)
.png)