Replacement
REPLACEMENT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the transfer case oil seal removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/ReplacedReplacement Part or Procedure | Necessary Procedures | Effect/Inoperative Function When Necessary Procedures are not Performed | Link |
|---|---|---|---|
CVT fluid |
ATF thermal degradation estimate reset |
The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly |
|
Bleed air from oil pump (continuously variable transaxle assembly) |
Stop and start system |
||
Front wheel alignment adjustment |
|
|
|
Reset memory |
Dynamic torque control AWD system |
||
No. 2 steering intermediate shaft assembly |
End position initial setting |
Power steering system |
|
Suspension, tires, etc. |
Rear television camera assembly optical axis (Back camera position setting) |
Parking assist monitor system |
|
Initialize headlight ECU sub-assembly LH |
Automatic headlight beam level control system |
HINT:
When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
- Learning completes when vehicle is driven
Effect/Inoperative Function When Necessary Procedures are not Performed
Necessary Procedures
Link
Front camera system
Drive the vehicle straight ahead at 15 km/h or more for 1 second or more.
.gif)
Stop and start system
Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)
.gif)
- Learning completes when vehicle is operated normally
Effect/Inoperative Function When Necessary Procedures are not Performed
Necessary Procedures
Link
Power door lock control system
- Back door opener
Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch.
.gif)
Power back door system
Fully close the back door by hand.
HINT:
Initialization is not necessary if the above procedures are performed while the back door is closed.
.gif)
Air conditioning system
After the ignition switch is turned to ON, the servo motor standard position is recognized.
-
PROCEDURE
1. REMOVE TRANSFER ASSEMBLY
Click here ![]()
2. SECURE TRANSFER ASSEMBLY
(a) Secure the transfer assembly to the overhaul attachment. |
![]() |
3. REMOVE TRANSFER CASE OIL SEAL
(a) Using SST, remove the transfer case oil seal from the transfer case. SST: 09308-00010 NOTICE:
|
![]() |
4. INSTALL TRANSFER CASE OIL SEAL
(a) Coat the lip of a new transfer case oil seal with MP grease.
(b) Using SST and a hammer, tap in the transfer case oil seal as shown in the illustration. SST: 09608-10010 SST: 09950-70010 09951-07100 Standard depth (A): 9.5 to 10.5 mm (0.375 to 0.413 in.) NOTICE:
|
![]() |
5. REMOVE TRANSFER ASSEMBLY
(a) Remove the transfer assembly from the overhaul attachment. |
![]() |
6. INSTALL TRANSFER ASSEMBLY
Click here ![]()


