Vehicle Exterior

Terminals Of Ecu

~2min read

TERMINALS OF ECU

CHECK POWER DISTRIBUTION BOX ASSEMBLY AND MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

(a) Remove the main body ECU (multiplex network body ECU).

Click here

*1

Power Distribution Box Assembly

*2

Main Body ECU (Multiplex Network Body ECU)

(b) Reconnect the power distribution box assembly connectors.

Click here

(c) Measure the voltage and resistance according to the value(s) in the table below.

Terminal No. (Symbol)

Terminal Description

Condition

Specified Condition

MB-13 (GND1) - Body ground

Ground

Always

Below 1 Ω

MB-26 (BECU) - Body ground

Auxiliary battery power supply

Ignition switch off

11 to 14 V

MB-27 (IGR) - Body ground

IG power supply

Ignition switch off

Below 1 V

Ignition switch ON

11 to 14 V

(d) Install the main body ECU (multiplex network body ECU).

Click here

(e) Measure the voltage and check for pulses according to the value(s) in the table below.

Terminal No. (Symbol)

Terminal Description

Condition

Specified Condition

8F-43 - Body ground

Rear window defogger signal (output)

Rear window defogger switch off

Below 1 V

Rear window defogger switch on

11 to 14 V

CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY

(a) Disconnect the I49 air conditioning amplifier assembly connector.

(b) Measure the voltage and resistance according to the value(s) in the table below.

HINT:

Measure the values on the wire harness side with the connector disconnected.

Terminal No. (Symbol)

Terminal Description

Condition

Specified Condition

I49-6 (IG+) - I49-17 (GND)

Power source (IG)

Ignition switch ON

11 to 14 V

Ignition switch off

Below 1 V

I49-17 (GND) - Body ground

Ground for main power supply

Always

Below 1 Ω

(c) Reconnect the I49 air conditioning amplifier assembly connector.

(d) Measure the voltage and check for pulses according to the value(s) in the table below.

Terminal No. (Symbol)

Terminal Description

Condition

Specified Condition

I49-1 (CANL) - I49-2 (CANH)

CAN communication system

CAN communication is performed

Pulse generation

I49-7 (LIN1) - I49-17 (GND)

LIN communication line

Ignition switch ON

Pulse generation

CHECK AIR CONDITIONING CONTROL ASSEMBLY

(a) Disconnect the I37 air conditioning control assembly connector.

(b) Measure the voltage and resistance according to the value(s) in the table below.

HINT:

Measure the values on the wire harness side with the connector disconnected.

Terminal No. (Symbol)

Terminal Description

Condition

Specified Condition

I37-9 (IG+) - I37-13 (GND)

Power source (IG)

Ignition switch ON

11 to 14 V

Ignition switch off

Below 1 V

I37-13 (GND) - Body ground

Ground

Always

Below 1 Ω

(c) Reconnect the I37 air conditioning control assembly connector.

(d) Check for pulses according to the value(s) in the table below.

Terminal No. (Symbol)

Terminal Description

Condition

Specified Condition

I37-7 (LIN1) - I37-13 (GND)

LIN communication line

Ignition switch ON

Pulse generation