There is No Sound Made
DESCRIPTION
Based on signals received from each ECU, the vehicle approaching speaker controller outputs warning sounds through the vehicle approaching speaker assembly.
WIRING DIAGRAM
NOTICE:
- Inspect the fuses for circuits related to this system before performing the following procedure.
- The acoustic vehicle alerting system uses the CAN communication system. Inspect the communication functions by following How to Proceed with Troubleshooting.
Click here
.gif)
PROCEDURE
CHECK FOR DTC
(a) Check for DTCs.
Body Electrical > Acoustic Vehicle Alerting System > Trouble CodesResult | Proceed to |
|---|---|
B135013 and B135019 are not output |
A |
B135013 and B135019 is output |
B |
| B | GO TO DTC CHART |
|
PERFORM ACTIVE TEST USING GTS
(a) Perform the Active Test according to the display on the GTS.
Body Electrical > Acoustic Vehicle Alerting System > Active TestTester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
Proximity Sound (20 km/h,12 mph) |
20 km/h vehicle proximity warning sound |
OFF or ON |
- |
Proximity Sound (20 km/h,12 mph)
Result | Proceed to |
|---|---|
The warning sound is produced |
A |
The warning sound is not produced |
B |
| A | REPLACE VEHICLE APPROACHING SPEAKER CONTROLLER |
|
CHECK HARNESS AND CONNECTOR (VEHICLE APPROACHING SPEAKER CONTROLLER - POWER SOURCE AND BODY GROUND)
(a) Disconnect the I256 vehicle approaching speaker controller connector.
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection | Condition | Specified Condition |
|---|---|---|
I256-7 (+B) - Body ground |
Ignition switch off |
11 to 14 V |
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
|---|---|---|
I256-12 (GND) - Body ground |
Always |
Below 1 Ω |
| OK | REPLACE VEHICLE APPROACHING SPEAKER CONTROLLER |
| NG | REPAIR OR REPLACE HARNESS OR CONNECTOR |