Suspension
Tire Pressure Warning Light Circuit
In this manual: Suspension
~1min read
DESCRIPTION
If the tire pressure warning ECU and receiver detects any problems, the tire pressure warning light blinks for 1 minute then illuminates, and tire pressure monitoring is disabled at the same time.
NOTICE:
- When replacing the tire pressure warning ECU and receiver, first use the GTS to record all of the current IDs and registered tires with transmitters of the tire pressure warning valve and transmitter registered to the tire pressure warning ECU and receiver.
- It is necessary to perform initialization after registration of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.
for Registration:
Click here
.gif)
for Initialization:
Click here
.gif)
PROCEDURE
CHECK FOR DTC (CAN COMMUNICATION SYSTEM)
(a) Check if CAN communication system DTCs are output.
- for Gasoline Model: Click here
.gif)
- for HEV Model: Click here
.gif)
Result | Proceed to |
|---|---|
DTCs are not output |
A |
DTCs are output |
B |
| B | GO TO CAN COMMUNICATION SYSTEM
|
|
CHECK COMBINATION METER ASSEMBLY
(a) Inspect the combination meter assembly.
Click here ![]()
| OK | REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER |
| NG | GO TO METER / GAUGE SYSTEM |
Was this page helpful?