Brake

Vsc Off Switch (for Instrument Panel Side)

~1min read

Removal

REMOVAL

COMPONENTS (REMOVAL)

Procedure

Part Name Code

1

LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

55432D

-

-

-

2

VSC OFF SWITCH

84988L

-

-

PROCEDURE

1. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

Click here

2. REMOVE VSC OFF SWITCH

(1) Using a screwdriver with its tip wrapped with protective tape, disengage the claws to remove the auto high beam switch.

Inspection

INSPECTION

PROCEDURE

1. INSPECT VSC OFF SWITCH

(a) Make sure that there is no looseness in the locking part and the connecting part of the connector.

OK:

The connector is securely connected.

*a

Component without harness connected

(VSC OFF Switch)

(b) Disconnect the VSC OFF switch connector.

(c) Check both the connector case and the terminals for deformation and corrosion.

OK:

No deformation or corrosion.

(d) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

5 (+) - 2 (E)

Switch pushed

Below 1 Ω

5 (+) - 2 (E)

Switch not pushed

10 kΩ or higher

HINT:

If the result is not as specified, replace the VSC OFF switch.

Installation

INSTALLATION

COMPONENTS (INSTALLATION)

Procedure

Part Name Code

1

VSC OFF SWITCH

84988L

-

-

-

2

LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

55432D

-

-

-

PROCEDURE

1. INSTALL VSC OFF SWITCH

2. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

Click here