Maintenance
Chassis
In this manual: Maintenance
11steps
~66min
3/5difficulty
Done 0 of 11
On–vehicle inspection 1. Inspect steering linkage
- check the steering wheel freeplay .
- check the steering linkage for looseness or damage.
- Check that the tie rod ends do not have excessive play.
- Check that the dust seals and boots are not damaged.
- Check that the boot clamps are not loose.
- check the steering gear housing for oil leakage.
If oil is leaking, find the cause and repair it.
- inspect the ball joints for excessive looseness.
- Jack up the front of the vehicle and place wooden blocks with a height of 180 to 200 mm (7.09 To 7.87 In.) Under the front tires.
- Lower the vehicle until the front coil spring has about half its ordinary load. Place stands under the vehicle for safety.
- Check that the front wheels are pointing straight ahead. Use chocks.
- Using a lever, pry up the end of the lower arm. Check the amount of play.
Maximum ball joint vertical play: 0 mm (0 in.) If there is any play, replace the ball joint.
- check the dust cover for damage.
- check the drive shaft boots for loose clamps, grease leakage, kink or damage.
- visually check the transaxle for oil (fluid) leakage.
If oil is leaking, find the cause and repair it.
Test yourself
A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?