Toyota Corolla Quiz
Diagnostics

Circuit description

In this manual: Diagnostics
Introduction — 31Preparation — 32Service specifications — 19Diagnostics — 497Engine control system — 6Fuel — 13Emission control — 28Exhaust — 3Cooling — 13Lubrication — 7Ignition — 3Starting & charging — 13Front suspension — 12Rear suspension — 9Tire & wheel — 1Drive shaft / propeller shaft — 15Brake — 42Automatic transmission / trans — 47Clutch — 19Steering column — 9Power steering — 11Heater & air conditioner — 20Supplemental restraint system — 27Seat belt — 12Lighting — 18Wiper & washer — 9Audio & visual — 12Wiring — 1Communication system — 1Windshield/windowglass/mirror — 31Seat — 10Theft deterrent & door lock — 10Sliding roof/convertible — 8Engine hood/door — 12Exterior/interior trim — 20Vehicle control system — 1Cruise control — 5Maintenance — 8
~1min read

This signal is used to detect that the brakes have been applied. The stp signal voltage is the same as the one supplied to the stop lights.

The stp signal is used mainly to control the fuel cut–off engine speed (the fuel cut–off engine speed is reduced slightly when the vehicle is braking.).

Wiring diagram
Toyota Corolla. Wiring diagram

Test yourself

A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.