Toyota Corolla Quiz
Diagnostics

Circuit description

In this manual: Diagnostics
Introduction — 31Preparation — 32Service specifications — 19Diagnostics — 497Engine control system — 6Fuel — 13Emission control — 28Exhaust — 3Cooling — 13Lubrication — 7Ignition — 3Starting & charging — 13Front suspension — 12Rear suspension — 9Tire & wheel — 1Drive shaft / propeller shaft — 15Brake — 42Automatic transmission / trans — 47Clutch — 19Steering column — 9Power steering — 11Heater & air conditioner — 20Supplemental restraint system — 27Seat belt — 12Lighting — 18Wiper & washer — 9Audio & visual — 12Wiring — 1Communication system — 1Windshield/windowglass/mirror — 31Seat — 10Theft deterrent & door lock — 10Sliding roof/convertible — 8Engine hood/door — 12Exterior/interior trim — 20Vehicle control system — 1Cruise control — 5Maintenance — 8
~1min read

Dtc output mode is set by connecting between tc and cg of the dlc3.

The dtcs are displayed by blinking the srs warning light.

Wiring diagram
Toyota Corolla. Wiring diagram
Hint

: when each warning light stays blinking, ground short in the wiring until the terminal tc of the dlc3 or internal ground short in each ecu is suspected.

Test yourself

A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.