Toyota Corolla Quiz
Introduction

How to proceed with troubleshooting

In this manual: Introduction
Introduction — 31Preparation — 32Service specifications — 19Diagnostics — 497Engine control system — 6Fuel — 13Emission control — 28Exhaust — 3Cooling — 13Lubrication — 7Ignition — 3Starting & charging — 13Front suspension — 12Rear suspension — 9Tire & wheel — 1Drive shaft / propeller shaft — 15Brake — 42Automatic transmission / trans — 47Clutch — 19Steering column — 9Power steering — 11Heater & air conditioner — 20Supplemental restraint system — 27Seat belt — 12Lighting — 18Wiper & washer — 9Audio & visual — 12Wiring — 1Communication system — 1Windshield/windowglass/mirror — 31Seat — 10Theft deterrent & door lock — 10Sliding roof/convertible — 8Engine hood/door — 12Exterior/interior trim — 20Vehicle control system — 1Cruise control — 5Maintenance — 8
5steps
~30min
2/5difficulty
Done 0 of 5
Hint

: carry out troubleshooting in accordance with the procedures on the following page. Here, only the basic procedures are shown. Details are provided in the diagnostics section, showing the most effective methods for each circuit. Confirm the troubleshooting procedures first for the relevant circuit before beginning troubleshooting of that circuit.

 1 Vehicle brought to workshop
2 Customer problem analysis
2 Customer problem analysis
  1. ask the customer about the conditions and environment when the problem occurred.
  2. Check the battery positive voltage.

    Voltage: 11 – 14 v (engine stopped)

  3. visually check the wire harness, connectors and fuses for open and short, etc.
  4. warm up the engine to the normal operating temperature.
  5. confirm the problem symptoms and conditions, and check for dtcs according to the related chart.
Ok go to step 5
4 Dtc chart
4 Dtc chart
  1. Check the results obtained in step 3, then confirm the inspection procedures for the system or the part which should be checked using the dtc chart.
Go to step 6 5 Problem symptoms chart
  1. Check the results obtained in step 3, then confirm the inspection procedures for the system or the part which should be checked using the problem symptoms table.
6 Circuit inspection or parts inspection
6 Circuit inspection or parts inspection
  1. Confirm the circuit for the system or the part which should be checked using the problem symptoms table or the results obtained in step 4.
7 Repair
7 Repair
  1. Repair the affected system or part in accordance with the instructions in step 6.
8 Confirmation test
8 Confirmation test
  1. After completing repairs, confirm that the problem has been solved (if the problem does not recur, perform a confirmation test under the same conditions and in the same environment as when it occurred for the first time).
End
End

Test yourself

A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.