Toyota Corolla Quiz
Diagnostics

Initialization

In this manual: Diagnostics
Introduction — 31Preparation — 32Service specifications — 19Diagnostics — 497Engine control system — 6Fuel — 13Emission control — 28Exhaust — 3Cooling — 13Lubrication — 7Ignition — 3Starting & charging — 13Front suspension — 12Rear suspension — 9Tire & wheel — 1Drive shaft / propeller shaft — 15Brake — 42Automatic transmission / trans — 47Clutch — 19Steering column — 9Power steering — 11Heater & air conditioner — 20Supplemental restraint system — 27Seat belt — 12Lighting — 18Wiper & washer — 9Audio & visual — 12Wiring — 1Communication system — 1Windshield/windowglass/mirror — 31Seat — 10Theft deterrent & door lock — 10Sliding roof/convertible — 8Engine hood/door — 12Exterior/interior trim — 20Vehicle control system — 1Cruise control — 5Maintenance — 8
4steps
~24min
2/5difficulty
Done 0 of 4
1. Reset memory Caution

: perform the reset memory (at initialization) when replacing the automatic transaxle assy, engine assy or ecm.

Notice

: hand–held tester only
  1. Turn the ignition switch off.
  2. connect the hand–held tester to the dlc3.
  3. turn the ignition switch to the on position.
  4. perform the reset memory procedure from the engine menu.
Caution

: after performing the reset memory, be sure to perform the road test described earlier.
Toyota Corolla. Reset memory

Test yourself

A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.